Search results
Armstrong's Best Practices Piping Diagrams for Steam and Condensate Systems. Steam Trap Location Points. Steam Main Header. condensate drain points with traps. Saturated Steam: Every 150-300 feet (25-50 m) Superheated Steam: Every 300-500 (50-75 m) Steam Valve Station Drainage. Install steam traps before normally closed manual valves, pressure.
Jun 19, 2023 · Consider factors such as pipe diameter, length, roughness, bends, fittings, valves, insulation thickness, ambient temperature, etc. Select a suitable pipe size for each section of the system that can carry the required steam flow with minimal pressure loss and cost.
Not only must steam traps be piped off the bottom of the steam lines, the pipe must be properly sized. If the condensate drip legs are too small, the condensate will simply blow past the drain line. Condensate drip legs should be sized according to the line they are draining. See the Chart for suggested sizes.
Learn about the essential link between the steam generator and the steam user, and the factors that influence the steam distribution system. Find out how to carry steam from a central source to the point of use, and how to reduce pressure and manage condensate.
Syllabus. Steam System: Properties of steam, Assessment of steam distribution losses, Steam leak-ages, Steam trapping, Condensate and flash steam recovery system, Identifying opportu-nities for energy savings. 3.1 Introduction. Steam has been a popular mode of conveying energy since the industrial revolution.
- 1MB
- 34
A steam system consists of a steam-supply/generating facility, a steam and condensate return/water piping system, and a steam-use facility (Figure 1). In this section, the discussion is focused on the integration of the various equipment within the steam-generating facility.
People also ask
How does a two-pipe steam distribution system work?
What is a steam trap piping system?
How are interior steam distribution systems classified?
What are the components of a steam system?
Interior steam distribution systems may be classified according to pipe arrangement, accessories used, method of returning condensate to the boiler, method of expelling air from the system, or the type of control used.
